Cosmetic tube manufacturers share the precautions for the use of cosmetic tubes

   Cosmetic tube manufacturers share the precautions for the use of cosmetic tubes
Nowadays, most cosmetics in life are made of tubes. The use of cosmetic tubes should be carefully combined with tubes and tube assemblies. Do not drag, kink or squash on sharp or abrasive surfaces. The following cosmetic tube manufacturers tell you about the precautions for the use of cosmetic tubes:
pressure
The pressure of the product filled into the tube (including the pulse pressure) shall not exceed the specified planned working pressure.
temperature
tube products must not be used at temperatures other than ttube specified or advocated by the tube manufacturer (including the temperature of the shipping materials and the ambient temperature).
Conveying material
It can only be used for the combination of tubes and planning information. If you are in doubt about its suitability, you can consult the tube manufacturer. When transporting potentially hazardous materials, such as toxic, corrosive, explosive and flammable materials, care should be taken to minimize the impact of leakage. When not in use, it is required not to fill the tube and tube assembly with the materials handed over.
surroundings
tubes and tube assemblies must not be used in environments other than the planned environment. If there is any doubt about its suitability or need to be used under special or different conditions, the tube manufacturer should be consulted.
Tortuous radius
The use of tubes and tube assemblies should not be less than the minimum bending radius specified or advocated by the tube manufacturer, otherwise the transported materials will be restricted. Avoid tortuosity or distortion near the tube connection, because continuous tortuosity in these directions will lead to increased fatigue damage of the tube, and then lead to premature damage to the tube ring.
Change stress
tubes and tube assemblies are generally not suitable for operation in a distorted state.
Tensile stress
As long as specially planned, the tube and tube assembly can accept tensile stress. If you have any questions about the suitability of the tube, you can consult the tube manufacturer.


Post time: Jul-14-2021